 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| Modem Interface Type D 9091 0210 Du line (R) Fieldbus Installationbus * 5 operation modes * Public line remote * Public line central * Private line master * Private line slave * RS 232 interface * Baud rate: 300, 1200, 2400, 4800, 9600 Baud * Protocols: Hayes AT and CCITT V.25 bis * LED-indications for supply, call initiate, external Dupline(R) OK and modem connection OK * AC power supply Product Description Dupline(R) interface for commonly available telephone modems (autodial or leased line). Hayes AT or CCITT V.25 protocol with selectable data format. Event, time or manually controlled connection between autonomously operated remote Dupline(R) installations and a central location. Ordering Key Type: Dupline(R) Type no. Supply D 9091 0210 024 Type Selection Supply 24 VAC 115 VAC 230 VAC No code module required Ordering no. D 9091 0210 024 D 9091 0210 115 D 9091 0210 230 Supply Specifications Power supply Rated operational voltage Installation cat. III (IEC 60664) 024 024 VAC 15% 115 115 VAC 15% 230 230 VAC 15% Frequency 45 to 65 Hz Voltage interruption 40 ms Power consumption Typ. 6 VA Rated operational withstand voltage 230 4 kV 024 800 V Dielectric voltage Supply - Dupline 4 kVAC (rms) Supply - Com. port 4 kVAC (rms) Supply - Input 4 kVAC (rms) Supply - Output 4 kVAC (rms) Input/Output Specifications Communication port Pin allocation TxD RxD GND DCD DTR RS 232 25 pole male SUB-D Pin 2 Pin 3 Pin 7 Pin 8 Pin 20 500 VAC (rms) Contact or NPN transistor 5 VDC 50 A 10 3m 500 VAC (rms) None Output Function Contact ratings (AgCdO) AC voltage AC1 DC voltage DC1 Load current Mechanical life Elect. life (at max. load) AC 1 Operating frequency Dielectric voltage Output - Electronics 1 SPDT relay Alarm (micro gap) 5A/48 VAC (240 VA) 0.7 A/48 VDC (33W) 100 mA 30 x 106 operations 2.5 x 105 operations 7200 operations/h 4 kVAC (rms) Dielectric voltage Com. port - Dupline(R) Dupline Tx inhibit input Open loop voltage Short-circuit current Contact resistance Cable length Dielectric voltage Input - Dupline(R) Input - Com. port Specifications are subject to change without notice (28.09.99) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group 1 D 9091 0210 Du line (R) Fieldbus Installationbus General Specifications Power ON delay Indication for Supply ON (PWR) Call initiate (CI) External Dupline OK (EXD) Modem connection OK (CON) Environment Degree of protection Pollution degree Operating temperature Storage temperature Humidity (non-condensing) Mechanical resistance Shock Vibration Material Weight 2s LED, green LED, green LED, yellow LED, yellow IP 20 3 (IEC 60664) 0 to +50C (+32 to +122F) -50 to +85C (-58 to +185F) 0 to 80% 15 G (11 ms) 2 G (6-55 Hz) Light grey polystyrol 600 g Additional Information Scope of supply 1 x Modem Interface 1 x Power cable, 2 m 1 x User manual D 9091 210... PWR 230 MAN D90xx ENG Dimensions (mm) Mode of Operation D 9091 0210 is a Dupline(R) modem interface for easy control of Dupline(R) networks through the telephone lines. Configuration of the interface is done by means of the configurator type D 9080 or by means of a personal computer running the terminal emulator software D 9091 SW01. The modem interface features 3 main functions for which it can be configured: public line mode, private line mode and RS 232 interface. For status indication 4 LEDs are used: * Call initiate (CI): to identify the dialling modem. * External Dupline(R) OK (EXD): indicating that the connected Dupline(R) is working properly. * Modem connection OK (CON): showing that connection is established between the 2 modems. * Power supply ON (PWR): to indicate that power is applied to the unit. The Run/program push button (5) (accessible with a pen through a hole on the right side of the housing) is used to switch the interface to configuration or Run-mode. When this push button is held down for 5 s the interface changes mode. Configuration mode is indicated by flashing of the three LEDs - CI, EXD and CON. The voltage selector switch (6) (only on D 9091 0210 230) is used to adapt the unit to the supply voltage. Note: The D 9091 0210 230 is factory set for 230 VAC. To change the supply voltage proceed as follows: 1. disconnect the power 2. remove the 4 housing screws at the bottom of the unit. 3. lift off the housing top cover 4. move switch (6) into position for selected voltage 5. reassemble the unit 6. change supply voltage label on the rear of the housing 7. connect power cable to power connector (7). The relay output (8) deenergizes whenever one of the following problems is detected: * Transmission breakdown * Continuous reception of corrupted data * External Dupline(R) off-line * Reception of an alarm call The Dupline(R) transmission inhibit input (10) is used to reset the data buffer and ignore the data received from the counterpart station. For more details, refer to the description in the manual. 2 Specifications are subject to change without notice (28.09.99) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group D 9091 0210 Du line (R) Fieldbus Installationbus Wiring Diagram Accessories Interface configurator Configuration software for PC: 3 1/2'' disc 5 1/4'' disc Configurator cable D 9080 D 9091 SW013 D 9091 SW015 RS 232-25M/25F Transmission inhibit Transm. Inh. To Modem, PC or configurator For further information refer to "Accessories". S: signal wire Power Supply Functional Description Rear view Top view 1) 2) 3) 4) 5) 6) 7) 8) 9) 10) 11) Supply ON-LED (PWR) Call initiate LED (CI) External Dupline(R) OK-LED (EXD) Modem connection OK-LED (CON) Run/program push button Supply voltage selector switch (D 9091 0210 230 only) Power connector Relay output terminals Dupline(R) connection terminals (S = signal, - = common) Dupline(R) Transmission inhibit input terminals Communication port to modem or configurator (D9080) Specifications are subject to change without notice (28.09.99) Dupline(R) is a registered trademark. A product of the CARLO GAVAZZI Group 3 |
Price & Availability of D90910210230
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |